Part Check

Ben-Irvine93 said:
Haha you had to state the obvious didn't you :p

What i ment was, I always think colour of things are different when viewing a picture on the internet than having them in your hand.

I always find them "different" if it makes any sense to you :confused:
Click to expand...

oh yeah, know what you mean :D:p

always4lora said:
cheers guys, will get my case on next payday and start buying the bits for water cooling
Click to expand...
look forward to it :D
 
another question.. does it matter where the radiator is attached? I've had an idea of cutting some holes in my current case and feeding the pipes through to the outside and having the radiator outside of the case? I presume this is the only bit that will be giving off much heat so the case inside will be nice and cool?
 
always4lora said:
another question.. does it matter where the radiator is attached? I've had an idea of cutting some holes in my current case and feeding the pipes through to the outside and having the radiator outside of the case? I presume this is the only bit that will be giving off much heat so the case inside will be nice and cool?
Click to expand...

Its fine anywhere as long as it has some air flow
 
coolio will add one to my 'wishlist' (will buy bit by bit should have them all within a few months). I presume none of the parts come with the barbs? So i'd need 2 for gpu,cpu, pump, res, rad? so 10 in total?
 
always4lora said:
coolio will add one to my 'wishlist' (will buy bit by bit should have them all within a few months). I presume none of the parts come with the barbs? So i'd need 2 for gpu,cpu, pump, res, rad? so 10 in total?
Click to expand...

2 fittings for each component, yes :)

Also, you may want to go for the alphacool top as it's a bit cheaper for the same thing :)
 
Cheers for the suggestion, i will go with that one:) the one from EK was about £48 i think.
The total so far is £350.17, EK do some brackets for fitting their radiators externally so getting some of them. I think it will be a worthwhile investment as once its all setup there wont be much in the way of cost.
 
always4lora said:
Cheers for the suggestion, i will go with that one:) the one from EK was about £48 i think.
The total so far is £350.17, EK do some brackets for fitting their radiators externally so getting some of them. I think it will be a worthwhile investment as once its all setup there wont be much in the way of cost.
Click to expand...

Koolance make an expensive, but very good bracket too :)
 
do i need to get the same make and model 120mm fans? or can i just mix them up? reason i'm asking is i might get some second hand gear and they don't always sell in 3's
 
You must log in or register to reply here.
Back
Top Bottom