Phaneks Enhoo 719 - I/O Panel - D-RGB Fan - M/B D-RGB 3 Pin Cable

embalse · 22 Oct 2020 at 21:29

Just bought a Phaneks Enhoo 719 These two cables from the I/O Panel: D-RGB Fan and M/B D-RGB 3 Pin. Should they both be connected to the motherboard (Asus x299 Sage)?

embalse · 23 Oct 2020 at 20:04

Well I have looked everywhere on my MB. I cannot find a socket that fits these D-RGB Fan plug....

Any ideas...

.

embalse · 23 Oct 2020 at 20:44

chaparral said:
Only this one goes to the motherboard

Hey thanks.

What do you do with the other one. The D-RGB Fan plug. Where does that normally go?

embalse · 23 Oct 2020 at 20:56

chaparral said:
Only this one goes to the motherboard

Think the other one for connecting more RGB accessories to (like RGB fans or RGB light strips)

I have an Evlov X case which has the same connectors

Thanks. It makes sense now.

.

embalse · 23 Oct 2020 at 21:01

chaparral said:
If you haven't already got it here a link to the PDF manual
http://www.phanteks.com/assets/manuals/Enthoo-719.pdf

Yes I have, but when reading the manual it did not make any sense as I have never really used RGB lighting before hence my post.

.

embalse · 23 Oct 2020 at 22:21

chaparral said:
I only had my evolv case about 1 month and i was puzzled about them extra connectors as it was also my first time using anything with RGB

Did your Evo come with a Fan hub? Did you connect the PWM fan plug from it to the CPU_FAN header on your MB?

embalse · 24 Oct 2020 at 13:13

chaparral said:
Yes my Evolv X came with a fan hub

I used to have the HUB plugged into the motherboard chassis fan 3 header but i now have it plugged into the external fan header on my GPU so the fans connected to the HUB are controlled by the GPU heat

My two CPU fans are plugged into my motherboard CPU fans header (there not connected to the Fan Hub)

You can see the wire from the Fan HUB plugged into the end of my GPU in this picture

Thanks..
.