Phanteks d30-120 question and pwm fan hub

seanuk · Friday at 12:15

Hi everyone so I have a ASU’s z790 apex encore and the problem is it’s a brilliant motherboard but has limited fan headers. I’m looking to upgrade my case to a phanteks nv7 but the problem is I will be running more case fans then I currently have 5x phanteks d30-120 fans connected to just one fan header. I am looking to run my fans through a phanteks fan hub that I have but they all daisy chain together so would it be ok to run 5 fans daisy chained into one specked on the fan hub? Thanks everyone

seanuk · Saturday at 08:54

Hi buddy thanks for your reply here is the one i have on tge following link: https://www.overclockers.co.uk/phanteks-universal-pwm-fan-hub-black-ca-08x-pt.html

seanuk · Saturday at 11:41

clone said:
I run 3x 3 D30 140mm on one header each and 2 140mm total 11 fans on My gigabyte board.

Thats my question though i domt have enough headera and getting more case fans so gping to use a fan controller but dont want to overload the controllernif you get me

seanuk · Saturday at 11:46

hornetstinger said:
I use artic fan hub, it has 10 outputs.

I cant individually plug each fan into itbas they daosy chaim togetjer so it will be like 3 fans on ome header on the controller and four fans on another header on the controller will that be ok?

seanuk · Saturday at 12:15

hornetstinger said:
I wouldn't stacking Y splitters on a hub.

How come you can't connect individual fans to the hub? It's fan power only doesn't have 3/4 pint RGB connector

Because the fans click together and only have one pwm connectpr on the cable

seanuk · Saturday at 12:42

WARburton said:
You will be fine. I’ve got the same controller

What fans you run on yours buddy

seanuk · Saturday at 13:50

WARburton said:
d30's always d30's i love the fans.
im running 3 blocks of 3 so 9 in total

how ever looking at the NV7 i dont know why you will have 5 in one link but i dont see you having a problem.
Phanteks do say not to link more than 4 this could be down to power draw or RGB restrictions. the RGB's draw 0.45 amps so having about 2.5amp pulling over one header maybe a problem i dont know.

Sorry i will have four on left side and three along bottom blowing up into gpu and a further two at rear blowimg out so in total so four connected together on one port then three together on one port then two together on one port you think thatbeill be fine or to many fans for the hub?

seanuk · Saturday at 14:51

seanuk said:
Sorry i will have four on left side and three along bottom blowing up into gpu and a further two at rear blowimg out so in total so four connected together on one port then three together on one port then two together on one port you think thatbeill be fine or to many fans for the hub?

Also how you controllong fan curves? You usinh bios or software?

seanuk · Saturday at 15:07

WARburton said:
i just use bios the fans at fixed at 35% system runs silent

Any pics of your setup? So all your fans run off your fan controller hub?