Phanteks PWM Hub Question

killaklik · 6 Jun 2017 at 17:42

Hi guys, I've just had delivery of

https://www.overclockers.co.uk/phanteks-pwm-fan-hub-ca-009-pt.html
and at the same time I got some fans, It turns out the fan headers / connectors are all 4pin rather than 3pin, about 5 years ago all the fans I purchased were 3 pin so I was surprised to see these were all 4 pin when they arrived. I'm obviously behind the times.

My question is, can I use the 4pin fans on the 3 pin hub controlling them all at the same speed via my bios, I plan on putting the fans on rads so don't need any individual speeds per fan.

I'm sure this question been asked before so apologies in advance.

Regards,

Michael

killaklik · 6 Jun 2017 at 22:39

Thanks for the suggestions guys, I never broke it's seal so I will probably send it back to Oc and go for a real PWM hub. I'm surprised that overclockers don't stock them given the variety of watercooling products they do stock.
Kudos doyll +Tealc.

killaklik · 6 Jun 2017 at 23:03

Thanks again guys, ended up ordering a SilverStone PWM Fan Hub System Cables, Black (CPF04). Sounds like it should do the trick,

killaklik · 7 Jun 2017 at 12:35

Thanks for the vote of confidence, got my email initiated with oc. So the balls rolling again on my new build.