Hi guys,
I bought a pre-overclocked machine and I had my BIOS reset to default, so I need to reapply my OC.
The settings I have been provided with are below, I cannot see the System Agent Voltage in my BIOS, only System Agent Offset. When I queried this I was told "Your board does'nt have system agent voltage so either leave that blank, or put it in the offset"
Doesn't sound too reassuring but I did it anyway, the offset value turned purple (which I'm told was ok) but after running the system for a couple of hours it blue screened. I restored the defaults and it ran fine all day so something is up with these settings.
Overclocked Intel® Core™i5-4670k Quad Core (3.40GHz @ max 4.20GHz)
ASUS® Z97-A:
16GB KINGSTON HYPER-X BEAST DUAL-DDR3 2133MHz X.M.P (2 x 8GB)
AI Overclock Tuner: XMP
BLCK Freq:
Turbo Ratio: By All Cores
By All Cores: 42
Internal PLL OverVoltage:
Mem Freq: XMP Default
EPU Power Saving: Disabled
Load-Line Calibration:
VRM Freq:
Phase Control:
Duty Contorl:
CPU Manual Voltage: 1.25V
DRAM Voltage: XMP Default
CPU Spread Spectrum: Disabled
CPU Ratio:
CPU C States: Disabled
EIST: Disabled
SVID Support: Disabled
System Agent Voltage: 0.4V
This machine was not purchased from Overclockers UK but I really hope you can give me some advice. I have never overclocked anything and don't want to break my new machine.
Thank you in advance.
I bought a pre-overclocked machine and I had my BIOS reset to default, so I need to reapply my OC.
The settings I have been provided with are below, I cannot see the System Agent Voltage in my BIOS, only System Agent Offset. When I queried this I was told "Your board does'nt have system agent voltage so either leave that blank, or put it in the offset"
Doesn't sound too reassuring but I did it anyway, the offset value turned purple (which I'm told was ok) but after running the system for a couple of hours it blue screened. I restored the defaults and it ran fine all day so something is up with these settings.
Overclocked Intel® Core™i5-4670k Quad Core (3.40GHz @ max 4.20GHz)
ASUS® Z97-A:
16GB KINGSTON HYPER-X BEAST DUAL-DDR3 2133MHz X.M.P (2 x 8GB)
AI Overclock Tuner: XMP
BLCK Freq:
Turbo Ratio: By All Cores
By All Cores: 42
Internal PLL OverVoltage:
Mem Freq: XMP Default
EPU Power Saving: Disabled
Load-Line Calibration:
VRM Freq:
Phase Control:
Duty Contorl:
CPU Manual Voltage: 1.25V
DRAM Voltage: XMP Default
CPU Spread Spectrum: Disabled
CPU Ratio:
CPU C States: Disabled
EIST: Disabled
SVID Support: Disabled
System Agent Voltage: 0.4V
This machine was not purchased from Overclockers UK but I really hope you can give me some advice. I have never overclocked anything and don't want to break my new machine.
Thank you in advance.
Last edited:
