Plumbers - three way ball valve

[Mat]

Is there such a thing as a 15mm 3 way ball valve that will allow me to do this:

The 'always open' is the washing machine and the 'sometimes open' is the external tap.

I'm trying to tidy up the plumbing under the kitchen sink and this would allow me to replace two pipes with one. It has to be fairly compact with compression fit if possible (I have no experience with any other joint type).

Ta!

 

[Nightglow]

Better to fit a T, & have seperate isolation valves.

Pushfit T would be easier to work with.

 

[Mat]

I did think of that but I don't think I have the room for the T and the isolation valve, hence the all-in-one solution :/

 

[Nightglow]

Can't think of any cheap 15mm 3 way ball valves, Norden, Jet,FlowCon, do a few 3 way valves, but they are ridiculously expensive


This is ok for washing machine, but no isolation for o/s tap, could use a in line stop valve for tap.

http://www.jgspeedfit.com/Home/Products/Valves/APPLIANCE-TEE.aspx

http://www.jgspeedfit.com/Home/Products/Valves/STOP-VALVE.aspx

 

[Mat]

This would be perfect... if the valve was on the other outlet!

http://www.clasohlson.com/uk/18-3315?gclid=CIOq3Kvh0L0CFQkEwwodmp4ALw

 

[Nightglow]

This would be perfect... if the valve was on the other outlet!

http://www.clasohlson.com/uk/18-3315?gclid=CIOq3Kvh0L0CFQkEwwodmp4ALw

Fit a additional in line valve for o/s tap.

http://www.screwfix.com/p/isolating-valve-with-handle-15mm/89226

 

[Mat]

This is essentially the space I have to work with; between the elbow and the T from the cold feed:

This elbow goes to the ext tap and you can just see the end of the current isolation tap on the left:

This is the other side of the isolation tap which is almost up against the T from the cold feed: