Hi Guys
I have a Polaroid 250s and use prusa slicer.
I load a model and the bed self levels the nozzle heats and states 'optimised' then extrudes a small amount of filament.
The machine then gets stuck on initialising and goes no further.
I have tried previously successfully printed files and get the same result.
Using head preheat it goes up to 150deg and shows that the head temperature is stable, no temp. reading is available during print,
I am currently using PETG at 240deg. But PLA setting does not work either.
I can't find anywhere to update/flash the firmware so am basically scuppered.
I did manage to get it to print by doing a filament change once but the print just stopped about 40% of the way through and said it was finished.
Any thoughts guys, would love some advice.
Cheers
KolinH
I have a Polaroid 250s and use prusa slicer.
I load a model and the bed self levels the nozzle heats and states 'optimised' then extrudes a small amount of filament.
The machine then gets stuck on initialising and goes no further.
I have tried previously successfully printed files and get the same result.
Using head preheat it goes up to 150deg and shows that the head temperature is stable, no temp. reading is available during print,
I am currently using PETG at 240deg. But PLA setting does not work either.
I can't find anywhere to update/flash the firmware so am basically scuppered.
I did manage to get it to print by doing a filament change once but the print just stopped about 40% of the way through and said it was finished.
Any thoughts guys, would love some advice.
Cheers
KolinH