Problem with PC getting no signal from monitor after sleep.

tempsgk · 16 Feb 2015 at 22:10

After putting the PC in Sleep Mode for the night. In the morning the PC does not register a signal. So obviously I restarted the system and still no signal.

So then I thought that it might be my monitor is bad, so I switched monitor and still no signal.

Ok so I then switch VGA cable to HDMI and still no damn signal. The monitor screen does not register the signal what so ever.

So yeah, any tips to get out of this problem?

tempsgk · 17 Feb 2015 at 17:08

Tried that, did not work...

tempsgk · 17 Feb 2015 at 19:36

@sammyboy13 tried that did not work.

@McGraw is it safe? How would I go into doing that?

tempsgk · 18 Feb 2015 at 20:47

Tried the Cmos Jumper, apparently didn't work. Will try removing the battery now.
http://dlcdnet.asus.com/pub/ASUS/mb/LGA1155/P8Z77-V_LX2/E7971_P8Z77_V-LX2.pdf

This is the manual I'm using. But can't find a segment telling the procedure to remove the battery.

tempsgk · 18 Feb 2015 at 21:11

Motherboard is the link above. Also I Tried with motherboard hdmi and gpu hdmi no different. So I doubt the GPU is at fault.

And thinking about it, I followed the manual and the manual might be wrong. After switching the jumper for 10 seconds and back, the manual ask me to power the PC on and assumes it work. But Other websites such as wikihow instructions is to keep the jumper at 2-3 pin and pressing the power button to discharge then puting the jumper cap back at 1-2 pin and finally connecting the electrical plug and powering the PC on.

tempsgk · 18 Feb 2015 at 22:00

Ok I unplug the PC, Remove the CMOS battery, Pressed and hold the power button for 15 seconds. Put the battery in, and start it up. Apparently still no Signal from monitor from all cables. Really I wonder what is going on.