prodigy m "atx" build?

bluntslide

bluntslide

bluntslide

Associate
Joined
25 Feb 2007
Posts
878
Location
leicestershire
So I was taking my matx board out and wondered if an atx would fit..


Going to need some work if this was done, particularly at the rear, then some new ste holes for board mounts but that's it!



Excuse the image quality but what do you think? Looks far easier than the mods that were done with the regular prodigy.
 
Last edited:
got about 1-2mm top and bottom, the back ports currently have some extra distance from the rear of the case because of the alignment. it is really tempting to go for this, might affect cable management slightly but looks doable!
 
Well, here we go.....
Removed the back and measured up for holes.


Drill out and threading in the new risers/mounts.


And what do you know? Slipped straight in there!
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom