Hi
1st time poster, been searching forum for advice, but any way i have a gigabyte DS3, E6300,Arctic pro 7 cooler, Corsair XMS2 6400 (2 gig) ram, X1950PRO with accelro fan and a Hiper 435 PSU.
but when i set FSB to anything over 266 it runs fine... until i reboot to adjust settings!!! When it either wont post or gives series of short beeps (according to handbook power error)
Usually i either have to reset the bios and setup all over again, or leave it for ten minutes or so and it boots up as standard setup.
Although i have had FSB at 400 running for an hour no problem,
memory 5-5-5-12
Following all guides for setting in various posts,
(Temps 35c idle 45c under TAT stress)
Until i reboot
So could it be PSU?
Ta in advance
Boobah!
1st time poster, been searching forum for advice, but any way i have a gigabyte DS3, E6300,Arctic pro 7 cooler, Corsair XMS2 6400 (2 gig) ram, X1950PRO with accelro fan and a Hiper 435 PSU.
but when i set FSB to anything over 266 it runs fine... until i reboot to adjust settings!!! When it either wont post or gives series of short beeps (according to handbook power error)
Usually i either have to reset the bios and setup all over again, or leave it for ten minutes or so and it boots up as standard setup.
Although i have had FSB at 400 running for an hour no problem,
memory 5-5-5-12
Following all guides for setting in various posts,
(Temps 35c idle 45c under TAT stress)
Until i reboot
So could it be PSU?
Ta in advance
Boobah!
Last edited: