#Pure sponsored by Thermaltake and MSI

AML Custom Pc

AML Custom Pc

AML Custom Pc

Associate
Joined
24 Feb 2017
Posts
82
Location
uk
Hey, thanks for checking out my build log for #Pure.



I couldn’t have done this build if it was not for the sponsors, MSI Thermaltake, To the wire sleeving.








This build will have a white, blue and frosted theme and I want the case to keep its external look and at the centre of the build it will have the Ryzen 2700x.


This is what I want to do,


[url=https://flic.kr/p/TbRT2S]


Parts l will be using,


CPU - Ryzen 2700x


Motherboard – MSI B450 tomahawk


Ram – Corsair Vengeance RGB 16gb


Graphics card – MSI Gaming RTX 2070


Storage – Unknown


Case – Thermaltake A500


Psu – Thermaltake Toughpower grand RGB 850W


CPU Block – Thermaltake Pacific W5


Rad – Thermaltake Pacific C360


Fittings – Thermaltake C- Pro


Pump – Thermaltake Pacific P1


PCI-E Cable – Thermaltake Premium 3.0 300mm.


I don’t want to keep this build on my bench too long so I have made a design and want to stick to it, I will be re-making all of the internals and we will just be keeping the frame and the external shell.



Here are a few photos of the products,



[url=https://flic.kr/p/2fe5ghy]



[url=https://flic.kr/p/RxpkuK]



[url=https://flic.kr/p/2fe5ge7]



[url=https://flic.kr/p/RxpkkX]



[url=https://flic.kr/p/2fe5gco]



[url=https://flic.kr/p/2fiKzYP]



[url=https://flic.kr/p/2fe5gbb]



[url=https://flic.kr/p/RxpkfX]



[url=https://flic.kr/p/2fiKzXM]



[url=https://flic.kr/p/RxpkeV][/url][/url][/url][/url][/url][/url][/url][/url][/url][/url][/url]
 
Hey, hope everyone had a good weekend.


So this is the case,








I remove psu cover and motherboard tray.





I made a model out of cardboard to make sure I got the correct sizes for the perplex





After I did this I removed the IO shield and graphics card supports from the back of the case so I can move this to the top of the case.














Once I cut the case up I new I would need to replace the back of the case, I made a quick design on fusion 360 and made a new back panel, this will include displayport and 2 usb 3.0.








I chopped down an old bracket for the thermaltake p3 to help support the graphics cards so it can hang down in the case.





This is the point I needed to stop as I needed to pick up the perplex for the next stage of the project.


This is where we are up to.


 
You must log in or register to reply here.
Back
Top Bottom