Qnix 1440p 120hz problem with 290x

yaboydom

yaboydom

yaboydom

Associate
Joined
20 Nov 2011
Posts
302
Hi all
Tried my best searching for any similar problems and can't find an answer.
I've got a recent new build with a ati 290x and a qnix 1440p monitor although i have a problem.
I can't seem to get any signal from the dvi-d from the gpu to dvi-d on the monitor , basically the screen just stays black.

I've got around this problem by going dvi-d from the gpu to hdmi on the monitor. but from what im aware of hdmi doesn't support 120hz refresh?

So i was wondering if any one has any solutions to this problem.

also i've tried a different cable and also a different machine 2500k gtx 660 works fine and can oc monitor with evga pixel overclock to 144hz just fine with dvi-d to dvi-d.

So both my cables seem fine mot really sure what i else i can check.
 
it's running at the native refresh rate currently at 75hz i don't get on using cru so haven't bothered to try OC on this fresh install.


just an FYI i get a signal when running dvi-d from the motherboard to dvi-d on the Monitor iy run's just like it should i haven't tried any games though i assume you can't run a games that way though?
 
Double check your cable. There are sightly different variants of DVI cables (DVI-D, DVI-I, double link, single link etc.)

I had a similar problem with a 280. Cable (single link DVI-D) worked fine with a 270X but not the 280. Switched to a dual link DVI-D and then it worked fine.
 
You must log in or register to reply here.
Back
Top Bottom