Question about loop

[bloodraven]

I do not really do custom loops but decided to do a loop.
Because my case is huge ( tower 900 ) i want the loops to be symmetrical though at this stage wont be looping in the GPU. So will this work?

( D5 ekwb res combo 300 ) Pump 1 right - outflow to cpu block
cpu block to a 560 rad ( right )
right rad to left pump ( D5 ekwb res combo 300 )
left pump to left rad 560
rad to pump 1 to complete the loop

 

[Mcnumpty2323]

Sounds right
Though would be easier to tell if
You did a diagram

May be an idea to do it all once you
Also have the gpu in the loop
As its extra work to do it afterwards/separately

Otherwise going to have to drain it
I Assume you have figured a drain point into the equation?

 

[bloodraven]

drain point, a port hole in the back / bottom of the chassis as the feet raise it by a few inches plenty of space and at back out of eye sight. I am looking into the block for a 3090 as its too early to take apart the 4090 or wait see if gigabyte brings out a 4090 extreme with WB pre installed like they did with the 30/80-90, 6900xt

 

[Mcnumpty2323]

Yeah I have castors on my case
So installed drain point underneath
Used a multiport radiator and put the drain on the bottom port
So it's absolutely the lowest point in the loop