Quick question about X58 memory voltages

Exsurgo

Exsurgo

Exsurgo

Associate
Joined
2 Oct 2009
Posts
829
Location
Belfast, UK
Currently on a quest to get my OCZ plats to run at 1866 Mhz. Currently they are unstable past 1333 Mhz even with relaxed timmings.

My problem is that if I set the DDR voltage to 1.64 in the Bios and reboot - the display will show the voltage as 1.71 even though 1.64 is shown as selected - therefore untill I can find out more I have it set at 1.58 which corresponds to 1.648 in the BIOS display.

Anyone else have any similar experiances with motherboard voltages for RAM?
Obviously if 1.71 where the true volts going through the RAM I would not be too happy.
 
Funny one that when i set my ram volt to 1.65 it stays at that maybe a bios update is needed?
 
Hmmm I will reflash it again maybe. Using the latest version atm. Are you using a Biostar mobo aswell?
It is Definatly is memory voltage that is holding my system back atm.

Have emailed Biostar about this but I expect to be waiting at least 24h for a reply.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom