Hello, every so often (Usually when my computer is turned off for an extended amount of time, overnight say) I would boot up the computer and the screen would have artifacts, white lines as such up until the windows loading screen then it would BSOD.
The problem presists after a restart and it ONLY occurs every few days or so, I've had it happen four of five times now with the same four to five days in between each BSOD. The only solution when it does happen, is to switch off the power by the mains and wait atleast ten seconds before turning it back on.
This has solved the problem every time it's happened and I've tried various things such as running Furmark for 20+ minutes, such intel burn test (30 times) On maximum without any errors, prime 95 for three hours without a single error. I've also tested ram with the windows inbuilt memory diagnostics without any problems and my next step will be to run memtest overnight (Hopefully tonight)
This is the error message I'm getting:
http://i44.tinypic.com/1052ys6.jpg
Other than this, I could say the system is running flawlessly on anything I've ran so far. Battlefield, Rendering on UDK and various other games.
System specs:
OcUK Geforce GTX 560ti 2048mb (Factory settings)
Corsair XMS3 2x4GB DDR3 1600MHz (I'm running the ram on 1333MHz as this specific ram requires 1.65v at 1600MHz and from what I've read, sandybridge systems dont support that much voltage running through the ram)
OCZ 650W Bronze PSU
Gigabyte Z68X-UD5 Intel Z68
1TB Seagate Barracuda 7200
I5-2500k 3.30Ghz sandybridge CPU (Overclocked to 4.5GHz)
OCZ Agility 3 60GB SSD
Antec Kuhler H20 920 CPU cooler
Regards
Aaron
The problem presists after a restart and it ONLY occurs every few days or so, I've had it happen four of five times now with the same four to five days in between each BSOD. The only solution when it does happen, is to switch off the power by the mains and wait atleast ten seconds before turning it back on.
This has solved the problem every time it's happened and I've tried various things such as running Furmark for 20+ minutes, such intel burn test (30 times) On maximum without any errors, prime 95 for three hours without a single error. I've also tested ram with the windows inbuilt memory diagnostics without any problems and my next step will be to run memtest overnight (Hopefully tonight)
This is the error message I'm getting:
http://i44.tinypic.com/1052ys6.jpg
Other than this, I could say the system is running flawlessly on anything I've ran so far. Battlefield, Rendering on UDK and various other games.
System specs:
OcUK Geforce GTX 560ti 2048mb (Factory settings)
Corsair XMS3 2x4GB DDR3 1600MHz (I'm running the ram on 1333MHz as this specific ram requires 1.65v at 1600MHz and from what I've read, sandybridge systems dont support that much voltage running through the ram)
OCZ 650W Bronze PSU
Gigabyte Z68X-UD5 Intel Z68
1TB Seagate Barracuda 7200
I5-2500k 3.30Ghz sandybridge CPU (Overclocked to 4.5GHz)
OCZ Agility 3 60GB SSD
Antec Kuhler H20 920 CPU cooler
Regards
Aaron
Last edited: