request ; case pics
- Thread starter utajoker
- Start date
http://files.tagworld.com/ca63f07050bd48a84464b13cace0b23c6956.jpeg
The HDD's have been reversed so that cables are largely hidden behind cage .
A small cut was made in the divider panel to allow for cabling/tubing to be routed.
The front USB/Firewire leads have been routed behind the mobo plate, and come out at top of picture. Just take off back side panel and route the cables using cable tidy's to keep them together.
Hope this helps you.
The HDD's have been reversed so that cables are largely hidden behind cage .
A small cut was made in the divider panel to allow for cabling/tubing to be routed.
The front USB/Firewire leads have been routed behind the mobo plate, and come out at top of picture. Just take off back side panel and route the cables using cable tidy's to keep them together.
Hope this helps you.
Last edited:
thx for the pic, i wanted to see how much space u get to play with and it looks like loads, that a 120.2 rad?
do u think u could fit a 120.3 or is the space why u went for a 210.2? i wouldnt want to have to hack holes in the case to make one fit
also i notice u dont use the 80mm fans, this for noise or is there no real point in using them?
do u think u could fit a 120.3 or is the space why u went for a 210.2? i wouldnt want to have to hack holes in the case to make one fit
also i notice u dont use the 80mm fans, this for noise or is there no real point in using them?
Yes it is a PA120.2 rad.
You can fit a PA120.3 in the bottom section, but you will need to remove the HDD rack to fit it in. You could house any HDD's in the 5.25" bays instead.
Both 120mm fans at front + back are in use - the front one has been housed in the space between the case front and the internal plate (see thumbscrews on fan retention plate) as this gives more room rather than squeezing in between the normal fixture between the internal plate and HDD rack.
If you install the rad in the bottom, you will need to cut 2 x 120mm circular holes for any fans. I have 2 x Panaflo 38mm fans that are underneath the rad and then have a Thermochill grill on the case floor.
You can fit a PA120.3 in the bottom section, but you will need to remove the HDD rack to fit it in. You could house any HDD's in the 5.25" bays instead.
Both 120mm fans at front + back are in use - the front one has been housed in the space between the case front and the internal plate (see thumbscrews on fan retention plate) as this gives more room rather than squeezing in between the normal fixture between the internal plate and HDD rack.
If you install the rad in the bottom, you will need to cut 2 x 120mm circular holes for any fans. I have 2 x Panaflo 38mm fans that are underneath the rad and then have a Thermochill grill on the case floor.