Retiring a 14 year old "legend"... and these new PSU's rock!!

Associate
Joined
12 Jun 2021
Posts
101
Location
London
No horror stories about hardware failing, I just decided my PSU from 2007 needed to retire gracefully as I have some plans to upgrade in 2022, so decided I might need some more headroom for a new GPU+CPU.

I used to run a lot of overclocked systems, so it was over-spec'd for the time and it has lasted really well... so the reason for upgrading early was just wanting something a little more efficient, quieter and more tidy (MASSIVE loom of "ketchup and mustard" SLI power rails, etc)... and so the next two upgrades would be quick swap-out, not entire chassis rebuilds.

Old device:
"PC Power and Cooling" 610W "Silencer" - the original Silencer, before there was a "mk ii","iii","iv"...
...and the original "80Plus" spec (before Bronze/Silver, etc) even existed.
Here's the "Legend" review for it from 2008 - note the 610W was the rated "continuous load" and it could run with significant bursts around 110%

New device:
Corsair HX850 (80Plus Platinum)
First impressions are just "WOW!":
Visuals: I do NOT do RGB/bling... and this is a very discreet, very clean install, I purchased the extra braided+combed loom as the stock cables looked like very hard plastic, so this is just so smart and tidy.... no more crushing the cable management behind the back of the case or into the HDD bays to gather dust!
Operation: unbelievably quiet... quite literally "silent" as the fan seldom spins due to it hardly being taxed at all: I think my little 2700X+GTX1660S require is probably <400W load at normal gaming "peak", although those predictor sites say it'll nudge close to 500W. I assume the noise will ramp up a little more with higher spec hardware being put through it's paces, but for now I'll enjoy the electricity bill savings and silence!

Sad to see the old PCP&C Silencer go.... 14 years of some pretty extreme usage (incl some 50% overclocks).... I'll be almightily impressed if the new one lasts this long!!
 
Last edited:
PC Power and Cooling built excellent psu's right up until OCZ took them over and run them into the ground. Until then they were some of the best psu's around.

Ah... that's what happened to them.... I know they're still around, but never "feature", especially in the UK market.

In their defence, OCZ made some of the best over-spec memory around.... they really should have just stuck to what they were good at!

You just reminded me that I've still got some OCZ RAM and that old "50%" OC-capable CPU lying around - it ran a spare downloads+file server until a few years ago and I even fired it up to test a few old SATA hard drives last summer that I didn't want anywhere near a new computer....

I was expecting capacitor pops and all sorts, but it ran fine. It's an Opteron 165 that was OC'd from 1800Mhz to 2700Mhz (with an overvolt and custom water loop - when it was used for gaming). When I replaced it with a Core2Quad, I repurposed the Opteron and stepped the OC back to 2250Mhz because it suited the OCZ PC4000 (500Mhz DDR) better. That was motherboard 200Mhz>>250Mhz, HyperTransport at 1Ghz (5:1 >> 4:1) and the CPU ran UNDER-volted to 1.25V (from 1.35V), so I could run it quieter - with an EVO120 "resistor"ed down to 500rpm, despite 2.25Ghz still being a 25% overclock on the CPU...
 
might need some more headroom for a new GPU+CPU.

In hindsight, that statement was a little unfair to the new AMD CPU:
1) changing from an 8 core, 16 thread 2700X to the 12 core, 24 thread 5900X..... 50% higher IPC, 50% more cores.... zero increase in peak power requirements.
2) GTX1660SUPER to RTX3080Ti.... over 200W extra.
 
Back
Top Bottom