Safety Camera feature on TomTom One

TechnoCorruption · 1 Jul 2008 at 16:25

When I bought my TomTom One a week ago it had a icon under preferences for safety cameras. Now that I have updated the software via the pc there is no longer the icon and there is nowhere to change any safety camera settings.

The unit picks up the cameras fine when I am driving down the road but is there anyway to make it beep or set off an alarm? The unit is not in my direct line of sight and a couple of times today I didn't see that it was flashing up a safety camera picture.

SB118 · 1 Jul 2008 at 16:33

You need to setup the speed camera Points Of Interest setting. then you can get it to give a warning when you are within range of the camera.

TechnoCorruption · 1 Jul 2008 at 16:36

SB118 said:
You need to setup the speed camera Points Of Interest setting. then you can get it to give a warning when you are within range of the camera.

How do I do that?

There doesn't seem to be any settings for safety camera anymore.

I have looked through the POI section and there is nothing in there?

Mark A · 1 Jul 2008 at 16:47

Ive noticed this today as well, since Ive updated it it doesn't beep or anything. I'll have a look at settings now see if i can see anything.

TechnoCorruption · 1 Jul 2008 at 16:51

I found out where the icon was,

It is under TomTom Services and not preferences (I could have swore I looked there a minute a go)

I have set an alarm for it now so will test it out on my travels tomorrow.