thanks i had to add one as i ran out of sata portsHard to say. I wouldn’t add a SAS HBA for a single drive though.
That was why I was considering moving to sas as I upgrade to save getting crosstalk errors with multiple data cables in the long termThen its a moot point, once you break the channel down to 4 SATA, it’s effectively 4xSATA. If you were running SAS its 2xSAS (SAS uses dual controllers). Could you jank something with 2XSATA and 1xSAS? probably, but you are adding multiple additional points of failure and cost for no obvious gain.
So can I ask I have two sata connected to this card if they were removed and only sas connected to the card would that be any better ?Then its a moot point, once you break the channel down to 4 SATA, it’s effectively 4xSATA. If you were running SAS its 2xSAS (SAS uses dual controllers). Could you jank something with 2XSATA and 1xSAS? probably, but you are adding multiple additional points of failure and cost for no obvious gain.
Thank youYou could run the channels independently with UR, so one is 4xSATA and the other is 2xSAS, but honestly, unless you get a seriously good deal on SAS drives, I would stick as you are.