Siftech MCP350 Pumps help

Skeng · 4 Jul 2010 at 21:32

Regarding this bad boy. http://overclockers.co.uk/showproduct.php?prodid=WC-005-SW

Well I'm after doing a dual loop my tubing and bards are 1/2" ID and 3/4" OD. I'm guessing my fittings wont fit this type of pump but will jubilee clips do nicely with that size tubing?

Bito · 4 Jul 2010 at 21:40

You can buy replacement pump tops which allow you to use the fittings to suit your tubing and give higher flow rates.

Skeng · 4 Jul 2010 at 21:48

Bito said:
You can buy replacement pump tops which allow you to use the fittings to suit your tubing and give higher flow rates.

How will the top go onto the pump? As I could do with the tubes being attached in the direction the pump is already showing on the pictures. As two of these need to fit in a small area under my Disk Drive.

johnny sublime · 4 Jul 2010 at 21:59

google koolance pump top that would be your best bet my friend

Skeng · 4 Jul 2010 at 22:18

johnny sublime said:
google koolance pump top that would be your best bet my friend

I bought them But I wouldnt mind a name for that Koolance pump top, I've seen it on google images but I have no model name for it so shopping for it is near impossible.

Bito · 5 Jul 2010 at 19:14

Koolance DDC Pump Top - Acrylic or Aquacomputer ddc pump top.....to fit them, you have to undo the four screws holding the current top on and then replace with the new top and supplied screws