What slicers are you guys using, I've always used Cura, simply because its what the guy at work used..
However I've recently started playing with Orca as its what the AnyCubic I'll be getting at some point is based on that, I've just printed the Storm Trooper out, and even on the same printer, it seems to be significantly better printed out sliced from Orca than it was printed from Cura..
Anyone else found this?
However I've recently started playing with Orca as its what the AnyCubic I'll be getting at some point is based on that, I've just printed the Storm Trooper out, and even on the same printer, it seems to be significantly better printed out sliced from Orca than it was printed from Cura..
Anyone else found this?