So I just got my P190... (Side panel question)

lazyvulture · 15 Feb 2008 at 12:52

I was just a little worried, as the side panel (the one without the fan) seems to just be held shut by the screws. It says that it swings open in the book, but it is bending slightly outwards in the middle. It this normal?

It is holding a few cables back (that's what is pushing it out).

If you didn't understand the above - I have to push the fanless side panel to get it closed, and then put screws in to hold it in place. Should it be like this?

lazyvulture · 15 Feb 2008 at 13:46

I tried to get a photo earlier, but it was really quite hard getting it displayed.

It is only out by a mm or two, but I am still worried.

I'll just re-jigg my cable management and see how it goes.

lazyvulture · 15 Feb 2008 at 13:53

*Sigh*

I'm not that retarded. I meant it was hard getting a decent photo DISPLAYING the problem.

lazyvulture · 15 Feb 2008 at 19:13

No the front is fine. It is the side.

I fixed it now though.

lazyvulture · 13 Mar 2008 at 19:43

Yeah, I got the modular second PSU.

It does HDDs, Molex and I'm pretty sure you can use other modular leads (Like from other PSUs).