Somethings telling porkies !!!

[PantsUK]

I'm getting different CPU speeds and or different temps depending on the program ...


whats lying !??!?

Thanks v much




Shot at 2007-08-08

 

[truebluecfc]

I cant hardly see anything on that picture but I kno Orthos doesnt recognise a multiplier change other than the chips default multiplier.

 

[Justintime]

From what i can make out, you're running at 8x400? Thats 3200MHz and correct, some programs read the multipler as the highest the chip is capable of instead of the current one hence why that program is saying 3600Mhz (its assuming 9x400), see your my computer properties, it'll say 3.6Ghz as well. As for temps, coretemp is usually right, download and run TAT to make sure.

 

[Justintime]

I cant hardly see anything on that picture but I kno Orthos doesnt recognise a multiplier change.

You see Orthos there? I need glasses!

 

[truebluecfc]

You see Orthos there? I need glasses!

No and i didnt say i could i meant some programs like Orthos sometimes dont recognise a multiplier change...

 

[PantsUK]

Just a small test

no Orphos


Shot at 2007-08-09

try that one. ... although I'm sure the multiplier lock is the reason ...

with regards temp is CoreTemp the most accurate ... in which case its a good 10 degrees higher than anything else.

Cheers

Pants

 

[truebluecfc]

Ya its your multiplier being 8 rather than 9, and download TAT to see if it matches up with CoreTemp although their a pretty good temps for a Quad at 3.2GHz.

 

[PantsUK]

even with a 120x3 water cooling ??? (only cooling the cpu)

 

[truebluecfc]

even with a 120x3 water cooling ??? (only cooling the cpu)

Well I dont know a lot about water cooling tbh, but 70c for a Quad Core OC'd to 3.2GHz under load isnt bad, just download and install TAT and see what that sais first.

 

[PantsUK]

between 65&67 for TAT .... guess that's ok