Spring Clean

_lecro_

_lecro_

_lecro_

Associate
Joined
10 Dec 2007
Posts
2,197
Location
South Yorkshire
Ok so my Obsideon system has been running flawlessly for 2 years now and i think its about time for a full service and a fw shiny additions :D
Already have new fluid,some nice red sickleflow fans ,
NB/SB block and some mosfets..

So im now thinking will it be over kill to drop a 240 rad in the bottom of my 800D ?
Ive also got a 120 rad left over from another project that didnt start which im planning on putting on the back outlet.

Also im going to be using masterclear tubing and dont want to use any angled connectors , just straight barbs .
So with that in mind what would be the best route for the tubing ?

ATM its going Res>pump>rad>cpu>gpu>res

EDIT : No there not nickel plexi before you ask Cleeecooo :)
 
Dont forget the mosfets/full board

Ive seen a lot on Youtube going with a horizontal links... looks good but if i start at the top theres going to be quit a bend from the main board to GPU.
 
Sweet temps .. are those with the i5 2500k .?
my 920s are much higher @4ghz
usually idle around 32-42 depending on heating
prime95 ... 49-58c
 
Last edited:
Sgt Tackleberry said:
My CPU is i5 2500k overclocked to 4.8ghz @ 1.37v.
My GPU is gtx 580 3gb @ Stock.
Click to expand...
Ahh That explains it , apparently the new i5/i7s are much cooler than the old ones

Anyway new goodies arrived today :D
3.jpg

2.jpg

1.jpg
 
I was going to get nickel plexi as everywhere i looked didnt have the black in stock but i came across some at the last minute ..

Woohoo some bitspower fittings just turned up :D

fittings.jpg
 
You must log in or register to reply here.
Back
Top Bottom