• Notice regarding image hosts and attachments. See here.

Start up problem since switching cases

Associate
Joined
30 Jun 2009
Posts
1,027
Location
Norwich
I rebuilt a computer on friday from a full to a mid tower and I finished everything only to find a problem. It was getting late so I left it so I could install one of my own purchases. I haven't looked at it since because I've been working but there's the thing.

When I plug the power cable into the wall and attach it to the power supply nothing (obviousy this is normal), but when I switch the power supply to on there is a buzzing, now this is before I try to turn it on. I try to turn it on and nothing.

I might have smelt something but I did have incense in the room.

just a power supply failure?
 
Check you haven't got something shorting somewhere. I managed to push out a molex pin whilst attaching fan power once, that then shorted to the case. Also remove and reseat motherboard power connections to make sure they are properly seated as thoeretically thats the only power live without it being on.

If not, probably a borked PSU.

M
 
Is the Kettle Lead all the way in? Did you use the motherboard stand offs?

I believe the connection was fine. The question is can you install a motherboard without the stand offs lol

They weren't the ones that came with the case as they were useless, the screws they supplied didn't create a good hold so I used the ones from the full case, including the washers.

I did a faff lot of cable management in the case and also modded extra fans to the side of the case and due to it getting late I didn't cross check after having the fault but everything should have been connected
 
Back
Top Bottom