Hi
Total beginner here, and just bought an Aquila C2.
All levelled several times, and printed out a calibration cube no problems.
Then I downloaded this photo holder from Thingiverse, and it's failed several times.
Is it just a bad design?
It goes fine until it gets to the "arms" or overhangs, and turns into a stringy mess.
Any ideas from the pic?
Total beginner here, and just bought an Aquila C2.
All levelled several times, and printed out a calibration cube no problems.
Then I downloaded this photo holder from Thingiverse, and it's failed several times.
Is it just a bad design?
It goes fine until it gets to the "arms" or overhangs, and turns into a stringy mess.
Any ideas from the pic?