system wont post:( help!

Burtoner · 29 Dec 2011 at 21:38

Had this system for just over a month

Asus P8Z68-V Motherboard and i5-2500k cpu

Decided to change ram from Consair Vengeance to Kingston HyperX and then the system just wouldn't boot, it was doing a startup and shutdown think the board does that with new ram going in, but i'm still not getting anything on screen. I have taken board and PSU out of case to try on a table, and still no joy. I even tried putting the old ram in, and also trying to reset the cmos, still no luck

Cpu fan is spinning so is graphics card, power light on board, and the red light for Mem OK?

All i wanted to do was change RAM over, and put my Noctua NH-D14 cooler on as it fits this ram

Burtoner · 29 Dec 2011 at 22:47

still tried no luck, I try the same process yet again from above, but this time with the RAM i previously used..

Burtoner · 30 Dec 2011 at 00:48

still no luck

I tested the graphics card on old motherboard and works fine, im sure its not the ram because I got 2 lot of different ram to try and it does same thing, only thing i left with it the cpu and motherboard.

Not very happy only brought board on 16th Nov

Burtoner · 30 Dec 2011 at 09:03

Well finally I got it booting off my new memory, havent a bloody clue what was going on..

Anyway all up and running again with new ram and noctua d14 cooler installed (all out of case at moment)

Max temp 57
Idle temp 25

Wow!

I was getting 38-45 idle and 86-90 temps before under load with stock cooler!