T-Line Fill Line.

[manymatt]

Hello all.

I've just finished installing a T-line into my system as I have been running a single bay repack res for a while and I find them impossible to bleed. The sloshing noise was driving me crazy so i decided to do somthing about it.

My question is this. Having always used res's to directly fill/bleed my system this is the first T-line installation, I'm not sure how far to fill it. At the moment the liquid is about an inch or two away from the t-connector, is this normal? or should i fill it right to the top? or doesn't it matter?

thanks
matt.

 

[***F1ZZY***]

It will work at any height but you will have to top it up more often if it is low to start with. You will notice the extent of evaporation from a loop more now as the loss is shown easily in a narrow tube [especially compared to the other end of the scale which is a bay res where its horizontal CSA is massive and you wont notice the water loss]. Even in a totally sealed loop you will experience loss (permeates throughthe tube walls). Bottom line is top it up almost to the top.