Taking the drain line off the graphics card?

Soldato
Joined
22 Dec 2008
Posts
10,369
Location
England
Hey. Thanks to sli, my ek full cover block has four holes in it.I'm inclined to take a drain line off from opposite the exhaust of the block. Is there any obvious reason why this is thick?
 
As long as there is enough thread depth to fit both barbs, if they are inline with each other, I don't see why not.
 
There might be. It looks like I'm pushing my luck with thread length slightly, so I think I'm going to take the move conventional route for the time being and run a t junction. Boring I know, but can always change my mind later, at which point I may well discover why I haven't seen it done before.

Cheers Bubo
 
Back
Top Bottom