TeamGroup Vulcan 2400MHz Timing help needed at 2000MHz

No such option unfortunately on this old board, so I have to run it at max supported, 2000MHz, and tighten the timings as much as possible manually.

Currently got it at 11-12-12-30-42-1t on stock volts which I set quickly earlyer and seems stable but not tested yet, will have time to spend on it in the morning but not sure what the max safe volts I can push or what timings at 2000MHz should be acheivable with this RAM?

A bit of a search and OLDPHART has the 2133 version of this RAM running at 10-11-11-30-1t, so I suppose that's a good starting point.

What is max safe volts though?

Thanks.
 
Last edited:
Thank You both, just done a few quick tests and here are the results @ 2000MHz 1.65v.

9-11-10-28-2T Boots and seems stable
9-11-10-28-1T Boots but not stable
8-11-10-28-2T No boot
9-10-10-28-2T No boot
9-11-9-28-2T No boot

Will have to leave it now till morning, here are the BIOS settings. Again thanks for your help.

bios1.png
bios3.png


bios2.png
 
TRFC doesn't allow manual input unfortunately, next step down is 160 but it won't boot even if I slack the timings to 11-12-12.

Would upping the voltage help?
 
I wish you had come along sooner, could have got something else.

For the price I wasn't expecting miracles but considering they are running 400MHz bellow rated I hoped the timings would do a bit better. My XMS3 is faster!
 
Last edited:
Ok thanks, just heard about haswell refresh though so will wait for that.

You were spot on with those timings (ofc) just got tRAS and tRC down a bit. Also gave 1T another go and strangely it's now stable, don't know why.

2000MHz | 9-11-10-22-36-1T | 1.65v
 
You must log in or register to reply here.
Back
Top Bottom