temps

windows20

windows20

windows20

Associate
Joined
10 Nov 2007
Posts
49
Location
newport
ok guys and girls
just installed my 2 dd 8800gts water blocks,think i have done it all ok.
this is all on 1 loop cpu and 2 gpu,so can any 1 tell me if my temps are ok or should they be lower.when i had just the cpu in loop it was about 48-50.
thanks
andy
Capture.gif



here are my load temps with prime.
Capture1.gif
 
Last edited:
keep forgeting to put my sig in :D
thought this might happen so what is the best rad for me to get,money is no probs.
andy
MM U2-UFO CASE
QX6700
Asus striker extreme (bios 1401)
Corsair dominator cm2x1024-6400 (x4@1g)
8800gts 640 x2 in sli
Thermaltake toughpower 1200w
Windows vista ultimate
Water Cooling
DTek fusion cpu
Laing ddcl ultra
Flow biohazard reservoir
Pro 360 rad
 
im on 1 loop at the mo because i want to try phase change.just waiting to see if i can get a cheap unit first,if not will put in second loop.no i have not got loads of cash,sold my bike last year and got into pc building and love it,so this is my new hobby.the wife says go for it so what the hell,not so easy to die on a pc as a bike;).so i think will try new rad see what that does for me.
thanks
andy
 
Last edited:
ok ordered my new rad,now is there any way i can slow my water pump a bit to see if that helps.there is a 4pin plug on the end with 2 wires in,then a single wire with a small 3pin plug on.so can i slow this pump down abit.
thanks
andy
 
just put my new rad in pa120.3 and these are what temps i got now.
load
Capture3.gif



Capture4.gif


the thing is,will i see much of a drop in temps if i put in a pa120.2.as well
thanks again
andy
sorry about this bit.i got a dtek cpu block how tight does this need to be.at the moment it moves about quite easy is this normal,or is it to loose.
 
Last edited:
got my cpu on its own now in a loop,temp gone down to 39-42.will have to get another pump and rad now to put my cards on.think its time to see what this baby can do now.
thank you all for the help.
andy
 
sorry guys time to do my cards now.
what i was thinking is,could i run 2 8mm tubes for each card,then put in a y piece to 3/8 tube.this way warm water will not be going to the second card.
sorry about the pic best i could do:D.
CIMG0159.jpg


thanks
andy
 
think i will try it this way just to see how i get on.done google to see if i could find some help but nothing about.did read some posts, people saying got the second card first in the loop and still getting hotter than the first card.so what the hell what i got 2 lose:).
andy
 
that done the trick,dropped down to between 34-38 now and its only been on 10 mins.done the thin line across this time with the arctic,and block is nice and tight.every thing looking good so far so will leave it be for a few days.
thanks for all the help all
andy
ps
will be moaning about my cards next lol
 
You must log in or register to reply here.
Back
Top Bottom