ThermoChill Radiator Fans Push / pull or both?

[nickrose]

Hi all

Just built my 1st watercooled loop (CPU Only).

On the ThermoChill PA120.3 Radiator , Thermochill recommend that the fans are setup in a pull config?

Anyone got any experience on a ThermoChill Radiator fan setup, should I leave as is now (Pull), put them on push or get another 3 and use push & pull.

I could leave until its running and check the temps, but while its still in bits, it would be easier to change now if anyone has any ideas on this.

I a using 3 x Scythe Kaze Jyuni 1900RPM fans.

Thanks for any advice

 

[Brizzles]

Very little difference in push, pull and push+pull.

I've tried all variations and not seen a signifcant difference.

A rad shroud might help , to eliminate dead spots from the fan, but i wouldn't bother with push+pull tbh.

A PA 120.3 will easily cool a CPU only loop, with bags to spare. I could almost run my Q6600 with the fans off on a PA120.3.

 

[prt]

got a ThermoChill PA120.3 Radiator with push pull on redwing 1500 rpm fans.
i notice a small diff when only running push or pull rather than push and pull. 4 to 5c