Things to look out for when fitting a block to GTX 680?

Soldato
Joined
22 May 2010
Posts
12,960
Location
Minibotpc
Is there anything i should be cautious about when fitting an EK block to my gtx 680? It'll be my first time (virgin) so i want to be as careful and as clear as possible as to what i'm doing...


My last watercooling moment was when i got my EK H20 kit where i punctured 2 rads -_-... don't want a repeat ofc!!!


Any Guidance would be much appreciated.

*looks at Cleeecooo*

Jay
 
Awesome guys, really looking forward to having a go myself! Will update with some pictures when it arrives :D


Should i cover the whole gpu chip like i do with the cpu and flatten it out with a spreader so it's even?
 
No thermal paste either :O?


Hmmm i have a lot left over from when i fitted my cpu block, should be okay.
 
I have some MX-4 paste left over :D


I've just checked my tool box and i dont have a T6.. the smallest i have is a T10!
 
Good thing you made this thread really.

I had about 20 mins to get to town and find a T6 before closing time.
Only had T8 at work as well so went with my Aquacomputer supplied one would be ok, it wasn't it died on the 2nd screw.
I found Homebase only went to T8 but Halfords had 1 T6 left but only for a socket tool.

it is haha, god knows what i would have done if i hadn't.

Just nipped out to Maplins to purchase a screw driver set that goes as low as T4 :). Should do the job, quality bit of kit aswel.. but pricey at £6.
 
Back
Top Bottom