• Notice regarding image hosts and attachments. See here.

TIM Advice.

Associate
Joined
27 Oct 2006
Posts
613
Location
Cotswolds, Nr Cheltenham
I have some Arctic Ceramic that I am trying to use on a lapped Q9450 and a H50.

I have reset a few times after not being happy with temps (50`c Idle rising to 70`c load @ stock with sides off case and 2 x Enermax Magma Push/Pull on H50).

I am concerned that I might be either putting too much on or that the Line across the CPU HS technique I am using is failing as I need to turn the H50 slightly when installing it (I hope that makes sense).

What is the recommended amount and technique to use with my kit?

I suppose I shouldn't need too much TIM as the CPU is lapped?

I also have a bottle of high purity isopropyl alcohol and a stack of coffee filters :D

Cheers
 
With single and dual cores i've always done the rice grain method but Arctic recommend a 1mm line travel across the middle of the CPU HS (apparently this covers each die of the quad) when using the Ceramique.

My confusion is arising because as I mentioned the Cooler twisting slightly which would then of course displace where the arctic ceramic is in relation to the die and a 1mm line as recommended is more than a grain of rice, its about 2 or even 3.
 
Back
Top Bottom