Titan fenrir
- Thread starter BeeP
- Start date
I'm not exactly an expert, but I have a p5n-e sli mobo and the sunbeam core contact freezer fits, and it's a similar HSF design. the sunbeam has 4.5mm clearance, maybe you can find out how much clearance the fenrir has from its site? I physically measured how tall my Northbridge heat fins were to make sure it would fit
If the motherboard adheres to ATX spec, then it should fit. This is likely. The issue is more likely to be with the case than the board as a lot of cases only give the recommended 3 inch space over the socket, and some coolers are taller than this.
A thermalright TRUE with a fan strapped to either side was a comfortable fit on my P5Q premium, and that looked massive. If really unsure though, I'm sure ocuk would tell you if you asked them via webnote.
A thermalright TRUE with a fan strapped to either side was a comfortable fit on my P5Q premium, and that looked massive. If really unsure though, I'm sure ocuk would tell you if you asked them via webnote.
Not quite so: the retention bracket has mounting holes for all sockets, and the AMx holes stick out a bit from the LGA775. When I was mounting one for someone on a 775 board we had to saw the AMx holes off to get it to fit with the VRM heatsinks.
In saying that, it looks like the P5Q-E has a bit more wiggle room, so it should be OK.