trouble with phantom 410 case :(

carbonado · 2 Jul 2013 at 16:05

i bought that case two days ago
unfortunitly my pc do not want work in
its perfectly fine in my old case
it turn on once but when i close sides do not work only blue led is on
i open sides again but still not working

please can any one help

Robbiec053 · 2 Jul 2013 at 16:09

Did you put the standoffs on the motherboard tray

these things:

HecFam · 2 Jul 2013 at 16:09

Make sure it isn't touching the sides of the case. Or any pieces of metal are connecting the two. You can always assemble it outside the case to see if the problem does only lie when it is inside the case.

Pic may be handy.

carbonado · 2 Jul 2013 at 16:28

yes i put the standoffs

and wose working for 5 minutes stop when i sites back and now just led on
could i broken motherboard ?

cypto · 2 Jul 2013 at 17:01

Double check and count the standoff screws for the motherboard and the number of standoffs in the case, sounds like something is shorting out.

You might have an extra standoff installed bridging a trace on the motherboard.

carbonado · 3 Jul 2013 at 00:22

i checked outside the case still this same , in old case still this same

but wose fine before all changing
i am afraid the motherboard is broken now because first time in new case i do not put any standoff because i do not have it in case before so i thought i do not need
thank you everyone for help

satanicguardian · 3 Jul 2013 at 10:02

carbonado said:
i checked outside the case still this same , in old case still this same but wose fine before all changing
i am afraid the motherboard is broken now because first time in new case i do not put any standoff because i do not have it in case before so i thought i do not need
thank you everyone for help

Hey, try assembling the most basic components you can on the motherboard cardboard box lid, so cpu, single ram stick (or as little as you can put in if using dual/tri/quad channel, don't even plug a storage device in.

Have you definitely connected the 4 pin cables for CPU? I've spend many an hour wondering why my pc won't boot after rebuilding, I'd just forgotten to plug the 4 pins back in, so it was doing nothing cause CPU wasn't powered on

carbonado · 4 Jul 2013 at 22:17

i still cant give up and trying to find out what is going on
and i have small questions i wose checking plugs and the 24 pin plug have one metal bit missing inside ( just like on picture) do that is normal ?

carbonado · 4 Jul 2013 at 22:18

paulstung · 7 Jul 2013 at 15:53

Does it have the ssd mount on the rear of the motherboard tray and if so are you using it ? With my 630, i had the same problem when putting the rear door back on it would either shut down or bsod, i found it to be the cables pushing either the ssd power or sata cable out.

carbonado · 14 Jul 2013 at 19:39

mmm will check
but I think I broke Motherboard or something when i turned off pc by switch on the powersuplay because I wanted to connect the rest of the stuff...

i bought PC diagnostic card and it not work however the LED on is on whats mean power going in just like with power LED on case ...

realy dont know now what to do may be just buy new motherboard ... :confused:

T345 · 17 Jul 2013 at 18:47

Is the RAM in the right slots?