Water block help!

almighty15 · 24 May 2014 at 21:36

I'm in the middle of doing a project and I need help finding a particular full cover water block!

As you guys know most full cover water blocks have the barbs in this orientation:

I however need a block with this orientation:

Ideally a block for either a R290, GTX780 or a 7990...

almighty15 · 24 May 2014 at 22:36

Tonester0011 said:
The CSQ blocks have the inlets ontop (when the link is attached, otherwise they're on the sides)

So I can use a CSQ block and put the barbs on the side?

almighty15 · 24 May 2014 at 22:37

Uncle Petey said:
Could you perhaps get away with using one or two 90 fittings to get them angled out like that?

There is literally no room

almighty15 · 24 May 2014 at 22:46

That might be too thick to use

almighty15 · 24 May 2014 at 23:25

Nope, the XSPC are also too thick... they litrally have to be like this

Or a very slow profile core only block...

almighty15 · 25 May 2014 at 00:28

Fully water cooling inside a Lian Li Q25B

240mm radiator is going in the bottom so with a 12mm slip stream fan only leaves a little room for a barb