Water cooling help

J1234 · 11 Jun 2006 at 22:25

The other day i installed all my water cooling gear, which consists of: Danger Den 5 1/4" bay res, Danger Den Maze 4 VGA Block, Thermochill CPU Water block (with 1 intake and two outakes) Danger Den CSP-MAG pump, and a 120.1 rad (all with 1/2" tubing) and it doesn't seem to be doing anything! The temp just keeps rising until it over heats and turns off. Bit puzzled as to whats happening. All blocks were applied with AS5 and the lopp is as follows: res>pump>rad>VGA block>CPU block>res. Am using PC Ice water. Can any one guide what i can do to fix this/change to get it working. Thanks in advange.

J1234 · 11 Jun 2006 at 22:28

Yes and yes

J1234 · 11 Jun 2006 at 22:32

I'm pretty sure it was because I remember tightening them up as tight as they could go.

J1234 · 11 Jun 2006 at 22:36

Yep the middle one was intake and the two were outakes. I will try tightening them, but i am not at home at the moment. Anything else you can suggest? Maybe the pump isnt powerful enough?

J1234 · 11 Jun 2006 at 23:06

When i turn it on it starts at about 45 degrees and rises in about mins before it turns off

J1234 · 12 Jun 2006 at 17:25

Still not back at home yet, I shall tell you what happens tomorrow. I think it propably isnt mounted properly because when i mounted my heatsink and fan it was very slightly loose and it had the same problem, and just a little bit of ajusting fixed it. Thanks for the help guys.

J1234 · 13 Jun 2006 at 20:42

Right, i've remounted all the cpu block, drained it all, and changed the loop round to res>pump>rad>cpu>gpu>res and its still doing the same, its getting so hot my thermal probe cant read it (which is over 80) I think it may be possible that my pump isnt powerful enough? Its the Dangerden CSP-MAG, but sue to its very small size i dont think its pumping very well, does anyone else use one of these? The power of it is 142GPH and i can't tell if the water is flowing or not?

J1234 · 13 Jun 2006 at 20:54

Its vibrating, and when i fill the system it pumps it round. Its to the side of the IHS not in between it and the block.

J1234 · 13 Jun 2006 at 20:56

Yep all brand new, its the thermalchill universal block, with 2 outlets and 1 inlet.

J1234 · 13 Jun 2006 at 21:07

What sort of ink?

J1234 · 13 Jun 2006 at 21:49

The pumo is working fine, i have found the problem, the cpu block wasnt touching the cpu propperly beacuse the cable from the thermal probe was in the way :rolleyes:

stupid me, cheers for the help guys!