Whats your E6600 oc?

My L268B is running at 380*9 - 3420mhz. Using 1.312v in CPUz which drops to 1.28v under load with Orthos. Stable as far as I can tell, no crashes yet, although I havnt let it run for hours and hours yet :)
 
E6600 @3.5GHz, 389MHz (x9) 1:1 (1.35v), Ram 4 x 1GB Crucial Ballistix (1.9v) 778MHz, 5-5-5-15, ran Orthos for a time, no errors..etc. runs well with all the applications I run on it, using Gigabyte GA P35 DS3P mobo. :)
 
Yeah, thing is though in the BIOS in is set to 1.3865v or something so going by CPUz its drooping by nearly .1v under load.

Dont suppose you'd happen to know what solder points on the P35C_DS3R show the vcore? :D

Also, tried FSB of 400*9 - 3.6ghz and even at 1.45v in the BIOS it fails Orthos in seconds, wondering what the safest voltage I can set it too is. It's 52C under load at 1.28v on water, imagine what it'd be at 1.5v actual :S

Ideas?
 
Any more, it needs a lot more volts and slacker mem timings.

Nucl1-1.jpg



.
 
currently running at a smidgen over 3.7ghz: 530FSB x 7 @ 1.55v

Fully loaded temps are about 47 / 48 degrees

It's booted at 3.9ghz before but found it hard to be stable

Need to lap the chip at some point, then bow the fuzion and add a nozzle kit :)
 
Hefner said:
currently running at a smidgen over 3.7ghz: 530FSB x 7 @ 1.55v

Fully loaded temps are about 47 / 48 degrees

It's booted at 3.9ghz before but found it hard to be stable

Need to lap the chip at some point, then bow the fuzion and add a nozzle kit :)
Click to expand...

what water setup you running? got swiftech apogee and 120.2 here
 
Using a PA120.3 in a push pull config, combined with a a DDC Ultra 18w with Petra's top, there's also an 8800 GTX block in the same loop which.

The 8800 is getting it's own loop soon though, so the CPU will have the 120.3 all to itself :p
 
You must log in or register to reply here.
Back
Top Bottom