wheres the leak???

Duesix · 19 Jul 2011 at 20:24

Probably not

unless you are experiencing flow problems.

The Asgard · 20 Jul 2011 at 07:14

It will be air. I had the same problem. You need to hold the res and turn the case through 360 degrees several times keeping the res upright. I thought I had removed all the air but after doing this I topped it up with another 1/2 litre.

vectisitch · 25 Jul 2011 at 00:21

i've just finished rebuilding my rig going over to sandybridge.i found a pinprick hole in the top 360 rad,only because i noticed a small green stain on it on one corner from the feser one.i soldered it and araldited it to be safe.

jorzeh · 25 Jul 2011 at 01:45

vectisitch said:
i've just finished rebuilding my rig going over to sandybridge.i found a pinprick hole in the top 360 rad,only because i noticed a small green stain on it on one corner from the feser one.i soldered it and araldited it to be safe.

What are you doing keeping Pins in your PC case!!!

Sorry couldn't resist : ))

Bubo · 25 Jul 2011 at 08:57

A noddy tip to find things like this is rads before you build is to connect a tube to one of the ports, blank off or cover the other port with your hand, submerge the rad completely in your kitchen sink full of water and blow in the tube. You would have had a stream of bubbles coming from the pinprick.