Which of these is the correct CPU Block Riser ? - Zalman Reserator 1 Plus

[Brizzles]

As title.

Bought a used Reserator 1 plus.

The previous owner didn't include the installation guide ( which i've found on the Zalman site ) and all the fittings for both the CPU and VGA block were just loose in the box ( Bless him ).

I've narrowed it down to two :

Which one do i use ?

( Socket 754 )

Cheers,

Mark

 

[00NukE]

Mark I have a C2D cpu and have the fittings on the left of your pic left over so guess those are the ones for you to use on your AMD will look at the fitting guide when I get home if you need any more help

Did you do the inlet tube mod ??

hope this is of some help

Steve 00NukE

 

[Brizzles]

Mark I have a C2D cpu and have the fittings on the left of your pic left over so guess those are the ones for you to use on your AMD will look at the fitting guide when I get home if you need any more help

Did you do the inlet tube mod ??

hope this is of some help

Steve 00NukE

Thanks Steve.

That was the one i was hoping someone would say, as it looks about the right depth and similar to some piccies i've seen.

As for the tubing mod, i'm still trying to unscrew the base !!

I've tried turning/unscrewing it, i tried using a piece of wood as a lever to unscrew it it wont budge.

Still waiting on a few other things before i strip down my rig and take the mobo out to fit the back plate.

Going to try heating it up next to see if that helps loosen the base.

Cheers for the reply.

Mark

 

[00NukE]

Hi Mark no probs
just a note it does have a rubber O ring seal similar to the top so take care with any heat.


Steve 00NukE