Which route should I go with?

[Bryan Kortez]

I am just planning my new loop. Using an existing Ax240 rad and a new 360 rad in the Fractal Define S case..

Some quick drawings of possible loops, any thoughts?

Or

 

[RyanF]

Looks good to me, although you want the loop from pump to GPU to extend to both GPUs otherwise no water will actually move around the top block it'll just pass straight through.

 

[Bryan Kortez]

Yeah true Think I had the loop running the other way round at one point lol

 

[NMBlack]

The second route looks neater.

 

[Bryan Kortez]

The second route looks neater.

That's the route I prefer atm, as it will allow for a fan to bring room temp air in as well.

 

[Deathjester]

I'd go with the second one, but I'd probably do the GPU's in parallel rather than in series.

Also, depending on the res, you should be able to go into the top of it rather than needing to loop to the bottom.

 

[Bryan Kortez]

I'd go with the second one, but I'd probably do the GPU's in parallel rather than in series.

Also, depending on the res, you should be able to go into the top of it rather than needing to loop to the bottom.

Yeah, was deff going to go parallel, just a **** up on the drawing (was originally running the loop the other way round so would have been parallel).

 

[RyanF]

Just realised they're two separate drawings I'd defo go with 2, looks much neater

 

[Glanza]

Are you piping between your gfx cards or using a bridge?

If pipe I'd recommend putting them in parallel.

 

[Bryan Kortez]

Are you piping between your gfx cards or using a bridge?

If pipe I'd recommend putting them in parallel.

Yeah, mentioned a few times above it's a **** up on the drawing ha

Would be piping anyway, much prefer the look over a bridge any day.

 

[BRIGGBOY81]

another vote for the second option here.