Hi Guys,
So I have just done a new build over the weekend, where I put in a second 680 into my Loop. I am using EK blocks with bridges.
I turned on the the system and at first noticed that I am only seeing one card. I uninstalled my Nvidia drivers and reinstalled and now I see both cards in device manager but I get error code 43 with the yellow exclamation mark.
Now I have been very careful, and there is absolutely no reason for the card to have gotten damaged during the install. and the card that is not working is the card I had been using before the rebuild so I know for a fact it was working without any problems (on water as well)
It would like to exhaust all options before I strip and drain my system!
Here is a list of my components:
Asus Rampage IV Gene
Intel i7 3930k
GeIL EVO Corsa 8GB (4x2GB) DDR3 PC3-17000C10 2133MHz
2x EVGA 680GTX SOC
Thanks.
So I have just done a new build over the weekend, where I put in a second 680 into my Loop. I am using EK blocks with bridges.
I turned on the the system and at first noticed that I am only seeing one card. I uninstalled my Nvidia drivers and reinstalled and now I see both cards in device manager but I get error code 43 with the yellow exclamation mark.
Now I have been very careful, and there is absolutely no reason for the card to have gotten damaged during the install. and the card that is not working is the card I had been using before the rebuild so I know for a fact it was working without any problems (on water as well)
It would like to exhaust all options before I strip and drain my system!
Here is a list of my components:
Asus Rampage IV Gene
Intel i7 3930k
GeIL EVO Corsa 8GB (4x2GB) DDR3 PC3-17000C10 2133MHz
2x EVGA 680GTX SOC
Thanks.
Last edited: