Windows explorer & server on network

mushtafa

mushtafa

mushtafa

Soldato
Joined
17 May 2013
Posts
2,976
Location
West Sussex, UK
I have a server running unraid with multiple shares setup.

Since a new install of Windows 10, it's not behaving correctly. It seems 50/50 if it's going to work or not.
When it does work, I have the server listed under Network in Windows Explorer and can navigate the shares. I also have two network drives mapped which work as they should.

When it doesn't work the server isn't shown in Windows Explorer. The mapped drives do not work. I get error 'Windows cannot access \\xxxxxx' '0x80070035'

If I use the run command and type the IP\share it works.

I've switched on SMB 1.0/CIFS File Sharing Support.

I've added the credentials of the share into Windows.

Any ideas please? I'm pretty sure it's an issue with the PC rather than the server
 
Rebooted the PC to check a BIOS setting to find it's now working properly again. I'm now sure it's a Windows problem
 
1. I've now disabled SMB1 again.
2. Just checked and found the Windows update.
3. When right clicking the mapped drives and looking at 'Target' is shows name rather than IP. I'll see if I can change it.
4. Yes, unraid has a static IP
5. I didn't try a ping, I'll do that when it fails next.
6. I have a user and password set for the shares. I've added these details into the credentials of Windows.
7. I'll do some research regarding a script.
8. What network info do you need? The server is connected to my R8000p via ethernet and using a static IP. The PC is also connected to the same wireless router, also using a static IP.
 
Thanks for the info. At the moment the mapped drives are showing and working, but I'm unable to navigate through the rest of the server in the network part of explorer. I assume this has disappeared since disabling SMB1? Will I have to map all the individual shares?
 
You must log in or register to reply here.
Back
Top Bottom