Been using this perfectly on 1920x1200 for months now.
Suddenly about an hour ago the screen went black and two lights were lit up on the card.
Reset and I could see the BIOS loading, windows 7 load screen but then black again.
Searched around and some people see to think its a refresh rate issue. So I booted into low res mode and was able to change the screen to any resolution except 1920x1200 (currently typing this on 1680x1050). If I attempt to change back up I just get a black screen again.
Had a play in CCC and couldn't find anything. Also deleted all drivers and CCC and problem is still there.
In the windows 7 resolution selection screen it says 1920x1080 is now the recommended resolution but obviously this is incorrect.
Can anyone advise?
Suddenly about an hour ago the screen went black and two lights were lit up on the card.
Reset and I could see the BIOS loading, windows 7 load screen but then black again.
Searched around and some people see to think its a refresh rate issue. So I booted into low res mode and was able to change the screen to any resolution except 1920x1200 (currently typing this on 1680x1050). If I attempt to change back up I just get a black screen again.
Had a play in CCC and couldn't find anything. Also deleted all drivers and CCC and problem is still there.
In the windows 7 resolution selection screen it says 1920x1080 is now the recommended resolution but obviously this is incorrect.
Can anyone advise?