yellow led for xspc raystorm

Nickolp1974 · 26 Oct 2012 at 15:22

not got the block just yet so dont know the size and where to look, any ideas folks????

could i just get some yellow led's, cut the blue ones off and solder the yellows on??? cant be a hard job????

Gregster · 26 Oct 2012 at 16:20

If they are the same size (they fit snugly into the block), it should be easy enough.

cammy5477 · 26 Oct 2012 at 16:24

I'm sure there 3mm mate

Nickolp1974 · 26 Oct 2012 at 16:41

thx guys

pgi947 · 26 Oct 2012 at 16:47

3mm is correct. Phobya are bound to do them.

Jay85 · 26 Oct 2012 at 16:50

one of overclockers competitors sell them, can't say which but they do them in the required 3mm size and will fit snug in the block. they come prefitted to a molex plug as well so plug and play pretty much.

Nickolp1974 · 26 Oct 2012 at 16:55

pgi947 said:
3mm is correct. Phobya are bound to do them.

Jay85 said:
one of overclockers competitors sell them, can't say which but they do them in the required 3mm size and will fit snug in the block. they come prefitted to a molex plug as well so plug and play pretty much.

so i'm looking for 3mm, thankyou

to add was gonna use the ek plexi block but was a bit worried about cracking so gone for the raystorm and hopefully with a yellow glow.

Mayhems · 27 Oct 2012 at 07:32

3mm yellow is about 0.35p be careful cutting as there is a resistor on the xspc ones that come with it.

Monkeyspaz5000 · 27 Oct 2012 at 14:37

Jay85 said:
one of overclockers competitors sell them, can't say which but they do them in the required 3mm size and will fit snug in the block. they come prefitted to a molex plug as well so plug and play pretty much.

Yip - as per above - you can get various colours. Not too costly either tbh.