your swiftech setup.

johnno said:
ye i will be installing this kit also into a pc7 does it fit ok. pictures would be great because help me to picture were the best place to put the pump e.t.c
Click to expand...

johnno, here you go

This is my first crack at wc, i decided to mount the pump and res using the hard drive bay because both of my hard drives are SilientMaxx'ed. The PC7 is surprisingly spacious so i didn’t have any real problems fitting it all in, its quite tidy also :D

Any questions just ask.

3.jpg


12-1.jpg


DSC02095.jpg


DSC02112.jpg
 
Alternative radiator mounting?

easyrider,

Is it possible to mount the radiator on the fans and Radbox so that the inlet / outlet connections point away from the case? If so, then by mounting the radiator the other way up (from the way you have it) with the water connections at the top, would it be possible to route the pipes out of the bottom of the case through a spare PCI slot without drilling any holes? Does this make sense?

Perhaps there would be a lot of tubing outside the case (in a loop between a lower PCI slot and the water connections at the top of the radiator) but no case mods would be required. I am keen to avoid such DIY!

Also, do you get the PCI pass through plate that ships with the Radbox kit (Rev 2)?

PCI Pass-thru kit:

Custom PCI bracket with U-shape holes for tube pass-thru and slotted hole for electrical routing.

Thanks.
 
MrFixit said:
easyrider,

Is it possible to mount the radiator on the fans and Radbox so that the inlet / outlet connections point away from the case? If so, then by mounting the radiator the other way up (from the way you have it) with the water connections at the top, would it be possible to route the pipes out of the bottom of the case through a spare PCI slot without drilling any holes? Does this make sense?

Perhaps there would be a lot of tubing outside the case (in a loop between a lower PCI slot and the water connections at the top of the radiator) but no case mods would be required. I am keen to avoid such DIY!

Also, do you get the PCI pass through plate that ships with the Radbox kit (Rev 2)?

PCI Pass-thru kit:

Custom PCI bracket with U-shape holes for tube pass-thru and slotted hole for electrical routing.

Thanks.
Click to expand...

that would work but look a bit pants.You would have loads of extra tubing that is not really needed.

On wether it would work?

Yes it would :)

I didn't really want to do any holes but I'm glad I did.
 
easyrider,

Agree about the look!

It's just that my wife would go mad if I start taking a power tool to what she thinks is HER PC! :eek:

Appreciate the help.
 
You must log in or register to reply here.
Back
Top Bottom