• Notice regarding image hosts and attachments. See here.

You've been Tangoed! Prodigy ITX Build log

Ive had a cpu and gpu on a 240 Rad and you are sensible to keep at stock volts, the problem with no cooling overhead is that it reaches the tipping point the heat goes up quickly.
 
OK, so crept CPU voltage up to 1.23, now @ 4.5ghz... Should I gun for more?

Overclocked Mem to 2133 mhz 9 9 9 27 2t and seen some nice increases in boot time and minimum FPS in games..

Not touched GPU...
 
just a quick question,
when you had the 7990, did you try the rotaries on the front of the card (rather than the back)?
or could it not fit so the case wouldnt close"?
 
Do you mean connect the water inlets to the side facing out?? If so you could maybe do it with 90 degree bends, it would just be hassle for no real gain.. If i have mis interpreted LMK.. I think you could prob fit it though (would be tight) if you needed / wanted to.
 
yea the sides facing out.
i've got a ut60 on the way and fittings will definitely not fit on the inward side, but there's not a lot of clearance for 90 deg rotaries with the ek 7990 block.
in a dilemma lol

where did you fit ur hdds? just in case i have no choice but to remove my hdd =x
and what size tubing did you use?
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom