Z77X UD5H Overclock

Here is my 1st overclocked @ 4.8GHz (4 Cores / 4 Threads) as temp not bads at 62C isn't it ?



Below is 4 cores and 8 threads - it seem get hotter with my thermalright silver arrow with dual 140mm fans with max speed hoover around 74C with 135Watts power from the cpu





What u think 8 pack, should I reduce vcore and change the settings in bios as I can await for your results next week when u will try out sandybridge with my board and see how far it go.
 
Last edited:
I try to get my head round it as the bios is alots of settings on it. I left VTT on Auto and PLL on Auto. I will try vtt and pll now. My memory ram is samsung green 2 x 4GB @ 1600MHz at 1.356v. Load Line Calibration set to Extreme.

Vcore Loadline Calibration and CPU VTT Loadlne Calibration had 8 settings are Auto, Normal, Standard, Low, Medium, High, Turbo and Extreme (I put Extreme on both)

PWM Phase Control had 7 settings are Auto, exm.Perf, High Perf, Perf, Balanced, Mid PWR and Lite PWR (I put exm.Perf)

Vcore Voltage Response had 3 seetings are Auto, Standard and Fast (I put Fast)
 
Last edited:
I had set mine 4.6GHz @ 1.320v with 2133mhz @ 9-11-11-21 1T @ 1.45v (the temp was not bad keeping at 70C because my room is very warm with central heating on) prime95 for 30 minutes full load

Thanks 8 pack for the correct timing on my memory ram which it pretty nice! :) I think I had to leave out 4.8GHz & 5.0GHz because it was far too hot. Need a proper custom water cooling!

 
Last edited:
You must log in or register to reply here.
Back
Top Bottom