LGA 775, SLI, MICROATX MOBO?

godinman · 29 May 2008 at 16:22

As above, does one of these exist? I think evga do an amd one...but i want an intel one!!

Thanks

Janesy B · 29 May 2008 at 16:22

you're more likely to get a blowjob off the queen

godinman · 29 May 2008 at 18:11

As exciting as the prospect is, i'd still rather a damn intel matx sli mobo!!

Damn...maybe midi-cases will be the closest i can get..

Urban Reflex · 29 May 2008 at 21:07

godinman said:
As exciting as the prospect is, i'd still rather a damn intel matx sli mobo!!

I dunno about that. Think of the money you could make off of the papers!

Seriously though, I don't think such a thing has even been dreamt into the realm of thought, let alone produced.

Janesy B · 30 May 2008 at 02:31

im strugling to keep one card cool in a very good matx case. i dont think id like two cards in there :|

malccy · 30 May 2008 at 07:53

Rumour has it that DFI are doing one.

V|per · 30 May 2008 at 11:29

malccy said:
Rumour has it that DFI are doing one.

Roumer be wrong? Still doesn't stop the fact that INTEL chipsets still don't support SLi, and i doubt there will be a mATX skulltrail board

Unless DFI are going to have an nvidia chpset based sli board...

As far as i am aware, you can go sli and mATX, but you'll be having to use an AMD chip.

godinman · 30 May 2008 at 15:28

Thanks for the replies guys, afraid i went to bed!!

My dream was to have a nice fast as ****, watercooled matx system...Athough thinking about it, SLI is **** anyway. Spose I could have a big single card solution...

Do you guys know if watercooling fits into microatx cases? Or would the rad have to be external to keep it out of the heat? Afraid i'm a bit of a watercooling noob...

Janesy B · 30 May 2008 at 15:33

godinman said:
Thanks for the replies guys, afraid i went to bed!!

My dream was to have a nice fast as ****, watercooled matx system...Athough thinking about it, SLI is **** anyway. Spose I could have a big single card solution...

Do you guys know if watercooling fits into microatx cases? Or would the rad have to be external to keep it out of the heat? Afraid i'm a bit of a watercooling noob...

if you are a noob i would avoid it. look @ my sig, my pc is stupidly fast and will run crysis at high settings without blowing a small hole in the surface of the earth. Im going to rebuild my system on monday with some cooling inprovements and i will post a build log for you guys

godinman · 30 May 2008 at 15:48

I did think that, but then, i've gotta start somewhere...Is your mATX watercooled? If so I shall look at your build log with interest. I wont be starting mine for a few months yet as it is, gotta buy a house first!

Janesy B · 30 May 2008 at 15:53

i havent bothered, it runs on air fine. i'm going to make a few mods to the case to fit two 120mm inlet fans for some nice fresh air, shut the hard disk up and improve cable management a bit. im also going to fit a smaller coolermaster heatsink with some mx-2 as i believe the Arctic Cooler 7 pro is taking up too much room and is having a negative effect on overall airflow. I dont think watercooling is viable in such a small case.

godinman · 30 May 2008 at 16:50

It was the whole silent thing that I was going for, i'm sure with a fair bit of case modding (**** loads) i'll be able to fit all the nessecary bits in..I've been looking for a bit of a project!!